14 Symbol LS4278
Pairing Methods
There are two pairing methods. The default method pairs (connects) the scanner
and cradle when the pairing bar code on the cradle is scanned. A second method
pairs the scanner and cradle when the scanner is inserted in the cradle. To enable
this feature, scan Enable Pair On Contacts below. With this feature enabled it is
not necessary to scan the pairing bar code on the cradle. If the pairing is
successful, a low/high connection beep sequence sounds a few seconds after the
scanner is placed in the cradle.
Carriage Return/Line Feed
To append a carriage return/line feed to all transmitted data, scan the following
bar codes in the order shown. To cancel this operation, the SET DEFAULTS bar
code on page 8, or refer to the Product Reference Guide.
NOTE If three scanners are actively connected to the cradle
(Multipoint-to-Point mode), a fourth scanner cannot connect
regardless of the pairing mode.
To Next Page
Loading...
