Chapter 4
Radio Usage
This section shows the ways you can use your radio.
4.1
Selecting Channels
For more details, see Channels and Frequencies on page 31.
Procedure:
1 Turn on the radio and press the Menu/Lock button until the channel number blinks.
• When the radio is on the 0.5 W channel, the Lo icon is displayed.
• When the radio is on the 2 W channel, the Hi icon is displayed.
• The current channel blinks.
2 To change the channel, press the + or - button.
Pressing and holding the keys allows you to scroll through the channel rapidly.
3 To confirm the channel and exit menu, press the PTT button.
You can continue the set-up by pressing the Menu/Lock button.
4.2
Selecting the Interference Eliminator Codes
Interference Eliminator Codes help minimize interference by blocking transmissions from unknown
sources. Your radio has 121 Interference Eliminator Codes. Codes 1–38 are standard analog codes
that appear on other Family Radio Service (FRS) radios. Codes 39–121 are additional digital codes
added for superior interference protection. 0 is the off position with analog or digital codes not enabled.
Procedure:
1 Press the Menu/Lock button until the code starts to blink.
2 To select the code, press the + or - button.
Pressing and holding the keys allows you to scroll through the codes rapidly.
3 To save the code setting and exit Menu, press the PTT button.
You can continue the set-up by pressing the Menu/Lock button.
NOTE:
You can set a different code for each channel using this procedure.
On a radio that uses Interference Eliminator Codes, the code must be set to 0 to
communicate with radios that do not have Interference Eliminator Codes. When you
select 0, the no tone, no code message displays on your radio.
MN009246A01-AA
Chapter 4 : Radio Usage
18
To Next Page
Loading...
Need help?
General
