How do I unlock my Motorola V150 Cell Phone?
If your Motorola Cell Phone display indicates that you need to unlock your phone, try entering the factory-preset unlock code (1234), or the last four digits of your phone number. If this doesn't work, call your service provider (the company that sends you your monthly wireless service bill).
Why can't I make or answer calls on my Motorola V150 Cell Phone?
If you cannot make or answer calls on your Motorola Cell Phone, ensure you have a phone signal. Try to avoid electrical or radio interference and obstructions like bridges, car parks, or tall buildings. Also, check if the Airplane mode feature is turned on. If you know the unlock code, you can change this setting in the security menu (M > > > ). Finally, verify that your SIM card is installed and working.
How do I unblock my Motorola V150 SIM card?
If your Motorola Cell Phone display indicates that you need to unblock your SIM card, call your service provider (the company that sends you your monthly wireless service bill) to get the PIN unblocking key (PUK) code.
What to do if the display of my Motorola V150 Cell Phone has stopped responding?
To address a Motorola Cell Phone that has stopped responding to key presses, you might need to reset your phone.
What to do if pressing the End/Power key on my Motorola Cell Phone does nothing?
Be sure to press and hold the End/Power key on your Motorola Cell Phone until the display appears and you hear an audible alert (this could take a couple of seconds). If nothing happens, check that the battery is charged.
What to do if my Motorola V150 didn't beep when I plugged in the data cable?
If your Motorola Cell Phone did not beep when you plugged in the data cable, make sure that both ends of the data cable are correctly connected—the smaller end to your phone and the larger end to your computer. Your computer might have deactivated the port to save power, so try opening an application that uses the port, like a fax or dial-up application, to automatically activate the port.
Why don't my fax and data applications work on my Motorola V150 Cell Phone after attaching the data cable?
If your Motorola Cell Phone beeped when you attached the data cable, but your fax and data applications don’t work, it may be because some wireless networks do not support data or fax transmission, especially if you are roaming on an unfamiliar network. Remember that data and fax transmission usually requires a subscription, so contact your service provider for details.
General| Brand | Motorola |
|---|---|
| Model | V150 |
| Category | Cell Phone |
| Language | English |
To Next Page
