34 August 20, 2003 6809471A67-O
Disassembly V150
Removing and Replacing the Microphone and Microphone Grommet
1. Remove the battery cover, battery, antenna, light guide, rear housing, and
transceiver board as described in the procedures.
2. As shown in Figure 14, pull the microphone assembly straight out of its socket
on the transceiver board.
3. Slip the grommet from the microphone.
4. To replace, slip the microphone into the microphone grommet as shown in the
figure, then insert the assembly into the socket on the transceiver board. The
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
031802o
Figure 14. Removing the Microphone and Microphone Grommet
G
Do not bend the microphone connector pins or damage the microphone case when
removing or replacing the microphone.
Microphone Boot
Microphone
Transceiver
Board Assy
To Next Page
Loading...
