32 August 20, 2003 6809471A67-O
Disassembly V150
Removing the Transceiver Board
1. Remove the battery cover, battery, antenna, light guide, and rear housing as
described in the procedures
.
2. Using the flat end of the disassembly tool, carefully lift the ZIF connector latch
on the transceiver board to unlock the flex (see Figure
12).
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
G
The flex cable is easily damaged. Exercise care when handling.
031799o
Figure 12. Disconnecting the Flex from the Transceiver Board
Flex Cable
Disassembly
Tool
ZIF Connector
Transceiver Board
To Next Page
Loading...
