26 September 28, 2004 6809490A38-O
Disassembly V551 GSM
Removing and Replacing the Metal Flip Shield
1. Remove the battery cover, battery, SIM card, antenna, rear housing, and
transceiver board assembly, flip assembly and the front flip cover as described
in the procedures.
2. Using a small screw driver, gently pry the metal flip shield off of the flip
assembly, exposing the rubber gasket.
3. Remove the rubber gasket.
4. To replace, align the rubber gasket onto the flip assembly and press in place.
5. Align the metal shield over the gasket and snap it in place.
6. Replace the flip front cover, flip assembly, transceiver board assembly, rear
housing, antenna, SIM card, battery, and battery cover as described in the
procedures.
Figure 14. Removing the Metal Flip Shield
Flip Assembly
(Pry Here)
(Pry Here)
Metal Shield
Rubber Gasket
To Next Page
Loading...
