28 September 28, 2004 6809490A38-O
Disassembly V551 GSM
Removing and Replacing the Flip/Vibrator Motor Flex
1. Remove the battery cover, battery, SIM card, antenna, rear housing, and
transceiver board assembly, flip assembly, the front flip, metal flip shield,
rubber gasket and the camera flex as described in the procedures.
2. Using the disassembly tool, gently pry up the flip/vibrator motor flex connector
fro the display board.
3. Remove the flip/vibrator motor flex from the flip assembly.
4. To replace, insert the flex through the slot in the flip hinge, align the flex
connector with the display connector and press it in place.
5. Replace the camera flex, rubber gasket, metal shield, flip front cover, flip
assembly, transceiver board assembly, rear housing, antenna, SIM card,
battery, and battery cover as described in the procedures.
Figure 16. Removing the Flip/Vibrator Motor Flex
Flex Connector
Display Board
Disassembly
Tool
Hinge Slot
To Next Page
Loading...
