June 22, 2006 31
Level 1-2 Service Manual Disassembly
PRELIMINARY
3. Pick one side of Speaker box hook into Main PCBA as shown in Figure 20.
4. Pick the othe side of Speaker box hook into Main PCBA.
5. Replace the PCBA, lower housing cover, battery, and battery door as described in the
procedures.
Removing and Replacing the RF Cap, Vibrator and battery connector
1. Remove the battery door, battery, lower housing cover, PCBA, antenna carrier as described
in the procedures.
2. Remove RF Cap, Vibrator, and Battery Connector from Housing D as shown in Figure 21.
3. To replace, align the lower housing cover and press into place.
4. Replace the antenna carrier, PCBA, lower housing cover, battery, and battery door as
described in the procedures.
Figure 20. Replacing the Speaker Box
Figure 21. Removing Vibrator and battery connector
To Next Page
Loading...
