32 June 22, 2006
Disassembly W220
PRELIMINARY
Removing and Replacing the Keypad and Hinge Stopper from Housing C
1. Remove the battery door, battery, lower housing cover, PCBA, antenna carrier, vibrator,
and battery connector as described in the procedures.
2. Remove the keypad and hinge stopper from Housing C as shown in Figure 22.
3. To replace, put keypad into the Housing C.
4. Replace the antenna carrier, PCBA, lower housing cover, battery, and battery door as
described in the procedures.
Figure 22. Removing the Keypad and Hinge Stopper
Figure 23. Replacing the Keypad and Hinge Stopper
To Next Page
Loading...
