Mountz HDC-35i - Torque, Speed & Angle Setting (I) - by PC Program

89 pages

To Next Page

To Previous Page

5.4 Torque, speed & angle setting (I) - by PC program

Set torque, speed & angle on the PC program and upload to the HDC controller,

then parameters will be set in the HDC controller.

Please refer the details to the article 9. PC program, Hi-Manager on page 65.

[ HDC setting menu on Hi-manager pc program ]

1080 N 11th St San Jose CA 95112

www.mountztorque.com 408.292.2214

Other manuals for Mountz HDC-35i