Mountz HDC-35i - Page 4

5.11 25P I/O port configuration
50
5.11.1 25P I/O configuration (I) - for Sensor
51
5.11.2 25P I/O configuration (II) - for PLC
52
5.11.3 25P I/O configuration (III) - for Sensor + PLC
53
5.11.4 25P Interface schematic - INPUT
54
5.11.5 25P Interface schematic - OUTPUT
55
5.11.6 Wiring of the Alarm signal to the Tower Lamp
56
5.11.7 Error code pin composition on 25P Output
56
5.12 25PIN I/O Timing Chart
57
5.13 Built in Screw Counter(patent)
58
5.13.1 Fastening quality verification
58
1) Fastening OK
58
2) Fastening NG
59
5.13.2 Count Start & Stop to HDC
60
5.13.3 Wiring of Count Start & Stop
64
5.13.4 Operation of screw counter on HDC
66
5.13.5 Operation of Model selecting
67
5.13.6 FND Display for Counter mode
68
5.13.7 FND Display for Model selecting
68
6. USB Communication
6.1 Port and cable
69
6.2 USB driver install
69
7. RS-232C Communication
69
7.1 Connection
70
7.2 Protocol
71
7.2.1 Protocol Frame
71
7.2.2 Communication control letters
71
1080 N 11th St San Jose CA 95112
www.mountztorque.com 408.292.2214
4