Mode Selections
With a torque sensor, this mode constantly tracks increasing or decreas-
ing torque variations. Use this mode to monitor varying torque on motors
and machinery. Also for calibration and testing of dial torque
products (small wrenches or dial screwdrivers).
Also used for force & load applications with a force sensor.
Track
Track 1500 Hz
+00.000 lbf.in
Menu Tool Tests
With a torque sensor, the display retains the highest torque applied. Use
this mode during calibration or testing of any hand type torque wrench
(dial, beam, and screwdriver), as well as power tools.
Also used for force & load applications with a force sensor.
Peak
Peak 1500 Hz
+ 25.010 lbf.in
Menu Tool Tests
The display holds the first detected torque peak applied. Before any
torque is applied, the display show dashes in the torque value area.
Once peak is detected, the display will show the torque value. If a
second peak is detected then it will be displayed in the lower right (in
small reverse video).
This function is primarily used for testing and calibrating click type
mechanical torque wrenches. The PTT captures the point where the
wrench clicks. This peak may be used for operator training on correct
use of the wrench. Always apply torque smoothly to avoid false first
peak readings. See page 13 for setting up First Peak.
Not applicable for Force & Load Sensors.
First Peak
FPK 3000 Hz
------- lbf.in
Menu Tool Tests
FPK 3000 Hz
5.4373
lbf.in
Menu Tool Tests
+7.6261
This mode is used to determine “first movement” or what is commonly
known as “break-away” torque to determine the actual torque on the
joint. An angle enabled transducer is required to operate in this mode.
See page 11 for setting up Angle Threshold.
Not applicable for Force & Load Sensors.
Audit
Audit 1500 Hz
10.510 lbf.in
Menu Tool Tests
This allows an operator to set up an initial torque and follow up with a
rotation to a specified angle and display the final torque.
The PTT can collect Torque and Angle data if the unit is connected to a
transducer that includes the angle function. It is a "Real Time" angle
function that can capture Torque and Angle up to 8000 RPM. See page
12 for setting up Torque + Angle.
Not applicable for Force & Load Sensors.
Torque + Angle
T+A 3000 Hz
9.9985 lbf.in 10 deg
Menu Tool Tests
Corporate Headquarters: 1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733
www.etorque.com
Page 8
0.00
To Next Page
Loading...