Movado Datron - Chronograph Operation and Reset (Type B); Operating the Chronograph; Basic, Accumulated, and Split-Time Functions; Resetting Chronograph Hands

22
To operate the CHRONOGRAPH:
This chronograph is able to measure and display time
in 1/5-of-a-second increments up to a maximum of
2 hours (4 revolutions of the 30-minute counter). To
save battery life, the chronograph will stop and reset
automatically after 2 hours of continuous running.
Simple chronograph functions:
1. Press button A to start chronograph; chronograph
hands C and E start moving.
2. Press button A a second time to stop chronograph;
read elapsed time indicated by hands C and E.
3. Press button B to reset chronograph hands to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a
football game, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated elapsed time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
Split-time or intermediate-time functions:
To take intermediate time readings as a race
progresses:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example:
11 minutes, 16.4 seconds.
4. Press button B to resume chronograph function. The
2 chronograph hands will quickly catch up with
ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional split
times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example:
24 minutes, 7.2 seconds.
8. Press button B to reset chronograph hands to zero.
To RESET Chronograph Hands:
After changing the battery, or in the event of an error,
the chronograph hands can be realigned to zero if
needed:
NOTE: To advance hands rapidly, press push buttons
and hold longer than one second.
Crown position 2:
Adjust minute-counter hand E using button B.
Crown position 3:
Adjust chronograph fifths-of-a-second hand C using
button A.
10
QUARTZ CHRONOGRAPH
1/5 OF A SECOND – TYPE B
Includes 40 mm Movado BOLD Luxe and select 38 mm Movado BOLD chronograph