30
14
QUARTZ CHRONOGRAPH
1/10 OF A SECOND – TYPE D
Includes Verto and select 38 mm Movado BOLD quartz chronographs
LEGEND:
H – Hour hand
M – Minute hand
C – Chronograph seconds hand
E – Chronograph 30-minutes counter
G – Chronograph tenths-of-a-second counter
S – Small seconds hand
D – Date window
1, 2, 3 – Crown positions
A – Chronograph push-button (start/stop)
B – Chronograph push-button (split-time/reset)
These quartz chronograph models feature a
tenths-of-a-second counter, minute counter (up to
30), and small seconds subdials; center-mounted
chronograph seconds hand; and date window.
They can be used to time an event up to 30
minutes and 60 seconds in duration to the nearest
1/10 of a second.
TIME/DATE SETTING
To set the time:
1. Pull crown out to position 3; watch stops.
2. Turn crown in either direction until hands indicate
desired time – check that the date changes at
midnight, not at noon.
NOTE: Date D will advance by one each time hour
hand H completes two clockwise revolutions, passing
midnight.
3. Push crown back in to position 1; watch restarts.
To adjust the date rapidly using crown:
1. Pull crown out to position 2; watch stops.
2. Turn crown counterclockwise to advance date.
3. When correct date is displayed in window D,
push crown back in to position 1; watch restarts.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. While the chronograph is running,
once the chronograph seconds counter hand C has
completed one turn, minute-counter hand E will jump
ahead one minute. Tenths-of-a-second hand G does
not move when the chronograph is running. Pressing
button A a second time will stop the chronograph and
move hand G to the relevant tenth-of-a-second mark.
Pressing button B will reset hands G, E and C to zero.
Adjusting the time does not stop the chronograph, but it
does block buttons A and B for as long as the crown is
pulled out.
IMPORTANT: Crown must be in position 1 and hands
must be at zero before chronograph is started. Press
button B to reset hands to zero. DO NOT push button
A or B while crown is pulled to position 2 or 3. If
button A or B is accidentally activated while crown is
not flush against case, one or more of the chronograph
hands will become de-synchronized. Should this occur,
follow instructions below.
Synchronization of chronograph hands:
After changing the battery, or in the event of an error,
the chronograph hands can be realigned to zero if
needed. A single push (quick press and release) will
FIGURE A
To Next Page
Loading...
