Movado Datron - Includes Original Movado Circa, Movado Master and Vizio Automatic Chronographs

37
TIME/DATE SETTING
To set the time:
1. Pull crown out to position 2; watch stops.
2. Turn crown in either direction to move hands to
desired time – check that the date changes at
midnight, not at noon.
3. Push crown back in to position 1; watch restarts.
To adjust the date rapidly using crown:
(see Figures A and B)
1. Pull crown out to position 2; watch stops.
2. Turn crown to move hands back and forth between
the hours of 9:00 PM (21H) and just past midnight
(24H); each time the hands hit midnight, the date
will advance by one.
3. When correct date is displayed in window J, push
crown back in to position 1; watch restarts.
To adjust the date rapidly using corrector (select
models only): (see Figure C)
IMPORTANT: DO NOT use the date corrector button
between 8:30 PM (20:30H) and 11:00 PM (23H)
when automatic calendar changes are in progress.
Doing so could damage the movement.
1. Depress date corrector button R, located along
the side of the case at 10 o’clock; each push and
release of button R will advance the date in window
J by one.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. While the chronograph is running,
the three chronograph counter hands will sweep
continuously, indicating the number of currently elapsed
seconds (hand C), minutes up to 30 (hand E), and
hours up to 12 (hand D). Pressing button A a second
time will stop the chronograph. Pressing button B will
reset hands C, E and D to zero.
IMPORTANT: The crown must be in position 1, and
hands must be at zero before the chronograph is
started. If necessary, press button B to reset to zero.
DO NOT use chronograph while crown is pulled out to
position 1.
DO NOT operate chronograph buttons A and B while
timepiece is under water.
NOTE: Hand S is the seconds hand for standard
time-keeping. It is not part of the chronograph function,
and therefore will run continuously while the crown is in
position 1.
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a
football match, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
16
AUTOMATIC CHRONOGRAPH
1/1 OF A SECOND – TYPE A
Includes original Movado Circa, Movado Master and Vizio automatic chronographs