44
the three chronograph counter hands will sweep
continuously, indicating the number of currently elapsed
seconds (hand C), minutes up to 30 (hand E), and
hours up to 12 (hand D). Pressing button A a second
time will stop the chronograph. Pressing button B will
reset hands C, E and D to zero.
IMPORTANT: The crown must be in position 1, and
hands must be at zero before the chronograph is
started. If necessary, press button B to reset to zero.
DO NOT use chronograph while crown is pulled out to
position 2 or 3. DO NOT operate chronograph buttons
A and B while timepiece is under water.
NOTE: Hand S is the seconds hand for standard time-
keeping. It is not part of the chronograph function, and
therefore will run continuously while the crown is in
position 1.
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a football
match, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read the elapsed time.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again and read combined elapsed time.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
19
AUTOMATIC CHRONOGRAPH
1/1 OF A SECOND – TYPE D
Includes SE Extreme and limited edition Movado Parlee automatic chronographs
To Next Page
Loading...
