56
7. Continue to turn crown counterclockwise until hour
and minute hands indicate correct time (8:35 PM),
being sure to take AM/PM time into account.
8. Push crown back in to position 1, and screw back
down into case.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to be
read. Pressing button A a third time will restart the
chronograph. Pressing button B will reset chronograph
hands C and E to zero. Adjusting the time does not
stop the chronograph, but it does block buttons A and
B for as long as the crown is pulled out.
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press button B
to reset hands to zero.
IMPORTANT: Do not push button A or B when crown
is pulled out to position 2 or 3. If button A or B is
accidentally activated while crown is not flush against
case, one or more of the chronograph hands may
become de-synchronized. Should this occur, follow
instructions at end for synchronizing chronograph hands.
Simple chronograph functions:
To measure the duration of a single, non-stop event:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph,
and read the 2 chronograph hands to determine
elapsed time, for example: 20 minutes, 38 seconds.
3. Press button B to reset chronograph hands to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a football
game, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time, for example: 15 minutes, 5
seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example: 20
minutes, 17 seconds.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
Split-time or intermediate-time functions:
To take intermediate time readings as a race
progresses:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example:
20 minutes, 17 seconds.
4. Press button B to resume chronograph function.
The 2 chronograph hands will quickly catch up with
ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional
split times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example:
29 minutes, 7 seconds.
8. Press button B to reset chronograph hands to zero.
25
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE C
Includes Movado Heritage Series Calendoplan chronograph models
To Next Page
Loading...
