Moxa Technologies UPORT 1130 User Manual

2
2. Installation and Configuration
Installation of the converter is a simple process. First install the driver, then plug the converter into a USB port.
When the converter is plugged in, Windows will load the correct drivers for the converter and the new COM port.
In this chapter, basic installation and configuration procedures are explained. Although the installation screens
will be for Windows 2000, the procedures are essentially the same for Windows 98 and later versions.
The following topics are covered in this chapter:

Initial Driver Installation
 Hardware Installation
 Windows 98/ME and Windows 2000
 Windows XP, Windows 2003/Vista, and Windows 2008 and 2012 (32-bit and 64-bit)
 Configuring the COM Port
 Configuring the Converter
 Removing the Converter
 Uninstalling the Driver

Advanced UPort 1100 Driver Functions

Enable Fixed-base COM Mode

Install Linux Driver
 Linux Kernel 2.4.20 and above
 Linux Kernel 2.6.x

Installing the Windows CE Driver
 Installation with an installation package for Win CE 6.0
 Installation with an installation package for Win CE 5.0
 Removing the Moxa WinCE 5.0 / CE 6.0 Driver
 Installation with a CAB File
 Removing the Moxa WinCE 5.0 / CE 6.0 Driver

Moxa Technologies UPORT 1130 Specifications

General

Connector 1	USB
Connector 2	DB-9M
Connector 1 gender	Male
Depth (imperial)	2.36 \
Width (imperial)	1.51 \
Height (imperial)	0.79 \
Weight (imperial)	0.14 lbs
Dimensions (WxDxH)	38.4 x 60 x 20 mm
Product color	Silver
Data transfer rate	0.012 Gbit/s
Compatible operating systems	Windows 98, ME, 2000, XP (x86/x64), 2003 (x86/x64), Vista (x86/x64) WinCE 5.0 Linux 2.6 (x86/x64), Linux 2.4 (x86/x64)
Input voltage	5 V

Weight and Dimensions

Weight	65 g