Moza Air 2S - Button Definition for Inception Mode; Balance Check; Balance Adjustment Guide

25
Button Definition for Inception Mode:
• Turn the joystick left or right: the gimbal turns to left or right, when release or turn to
a specified angle, the gimbal stops.
• Turn the dial: adjust the rotation speed
• Press the left button on the dial once: the gimbal rotates to the left automatically. If
the gimbal is rotating, press once to stop.
• Press right button on the dial once: the gimbal rotates to the right automatically. If
the gimbal is rotating, press once to stop.
• Press up/down button on the dial: select rotation angle
• Normal: gimbal rotates and does not stop automatically
• 180: the gimbal rotates 180° and stops automatically.
• 360: the gimbal rotates 360° and stops automatically.
Triple click the right button again to exit the Inception Mode.
Balance Check
• The gimbal can check the balance status of tilt and roll axis automatically and
instruct users to make the correct adjustment.
• Attach a tripod to the gimbal, turn on the gimbal and place it on a horizontal
tabletop.
• Enter the menu, select advanced>balance chk, the gimbal begins to check the
balance adjustment.
•
• When balance check is completed, the balance status of each axis will be displayed
on the screen, direction guide will be also displayed if the adjustment is needed.
• ' C ' means quick release plate, ' T ' means tilt axis, ' R ' means roll axis, then start the
adjustment according to the screen prompts.
• When adjustment is completed, press the right button and check it again until the
gimbal is well balanced.
Note:
1. Balance check can be only used with the tilt and roll axis, the pan axis balance
cannot be checked, please check the pan axis manually. Be sure that the motor
lock has been released when using balance check.
2. Motors turned off after balance check, please long press ‘menu’ button to
start the gimbal.