Note:
1. Please keep the gimbal stationary during the calibration, any shaking will
cause the calibration to deviate.
2. Any drastic shaking might cause ’err’ shown on the screen, please calibrate
again.
3. Do not arbitrarily perform calibration operations while it is not necessary.
Offset
In case of emergency shooting, the camera cannot be leveled and there is no time for
sensor calibration, the camera can be adjusted to a horizontal state by offset.
• Turn on the gimbal and the camera level, check the offset of the tilt and yaw axis.
• Enter the menu, select advanced>calibrate>offset, select an axis that is not
horizontal, and then turn the dial to adjust the fine adjustment value of the axis until
the camera completely keeps level.
Notes:
1. The offset can only adjust the angle of each axis within the range of about
±5°, if there is too much offset, the camera cannot be completely leveled.
2. Offset is only a temporary solution, after shooting, accelerometer calibration
is still needed.
3. The parameters of the offset will not be saved and will become invalid after
restart.
Language Switch
The Air 2S supports both Chinese and English. After turning on the gimbal, users can
switch language in the menu.
User Configuration Management
The Air 2S can save 3 groups of user data like camera type, motor output, button
operations and other parameters, so users can retrieve relevant parameters previously
used and avoid trouble of setting parameters each time when changing the camera.
When configuration data is confusing, users can select “restore configuration” to clear all
previous configuration data.
To Next Page
Loading...
