MPPT SPT-10A - Parameter Settings; Load Mode Configuration

17
Parameters setting
Load mode setting
Set Load modes under below interface.
Operating Steps:
Under load mode setting interface, press ENTER button and hold on 5s till the number
begin flashing, then press SELECT button to set the parameter, press ENTER button to
confirm.
Time 1
Time 2
Light ON/OFF
Disabled
Load will be on for 1 hour
since sunset
Load will be on for
1 hour before
sunrise
Load will be on for 2 hours
since sunset
Load will be on for
2 hours before
sunrise
Load will be on for 3~13
hours since sunset
Load will be on for
3~13 hours before
sunrise
Load will be on for 14 hours
since sunset
Load will be on for
14 hours before
sunrise
Load will be on for 15 hours
since sunset
Load will be on for
15 hours before
sunrise
Test mode
Disabled
Manual mode (Default load
ON)
Disabled
NOTE: Please set Light ON/OFF, Test mode and Manual mode via Timer1. Timer2 will be
disabled and dispIay “ ”.