MSA 9020 SIL - Access Code 6 - Basic Setup

40
Settings Parameters
GB
Model 9010/9020 SIL
5.5 Access Code 6 - Basic Setup
Step Function
P1
Display Firmware and Bootloader Version
Example: F1.01 - Firmware version
1001 - Firmware build number
B1.01 - Bootloader version
1001 - Bootloader build number
P2
ATEX Mode
A= ATEX mode activated
nA = non ATEX mode activated
If ATEX mode is set then some functions are limited according to ATEX Directive or general
safety requirements
P3
Start-up Sound
Activates sound beep in case of start-up
on= enabled
off = disabled
P4
Key Press Sound
on= enabled
off= disabled
P5
Date
Set system date (YYYY/MM/DD format)
P6
Time
Set system time (HH/MM/SS format)
P7
Display Serial Number
Serial number is displayed in sections of 4 digits
For scrolling the number on a display press ENTER key
P8
Set Beeper Mode
Allows to set different sound options being generated by internal beeper in case of HORN relay
is activated:
OFF - Beeper is inhibited
1, 2, 3 - Select different number for different sound of the beeper.