EasyManua.ls Logo

MSA EVOLUTION 5000 - Service and Field Repairs; Internal PCB Fuse Replacement

MSA EVOLUTION 5000
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
GB
GB
Service
If your EVOLUTION 5000 Thermal Imaging Camera (TIC) is in
need of service or repair, please contact the MSA European
Repair Centre at + 49 30 6886 555. Describe the problem to
the Representative as completely as possible.
1. Verify with your Representative that the product should be
returned to MSA.
2. Before returning the product, decontaminate and clean
your Thermal Imaging Camera to remove any hazardous
materials that may have settled on the product during use.
Truck-Mounted Charging System Field
Repairs
Note:
Only remove the Truck-Mounted Charging System’s
back cover after the unit has been disconnected from the
power source.
Internal PCB Fuse Replacement
x Power LED will not light and other troubleshooting
guidelines do not resolve the problem.
1. Remove charger from mounting brackets. Using a screw-
driver, remove the three retaining clips from the plastic
bosses and remove the back cover.
2. Disconnect the power hook-up cable by disconnecting the
Phoenix connector from the plug-in receptacle on the
upper right side of the printed circuit board panel.
3. The internal printed circuit board fuse is located next to the
Phoenix connector on the circuit board. Remove the fuse
using the plastic, non-conductive tweezers and replace it
with a new fuse.
4. Reconnect the power hook-up cable to the Phoenix con-
nector and replace the back cover. Secure the cover with
the retaining clips and bolt it back to the mounting
brackets.
10. Ordering Information
Spare Part / Accessory Part No.
Desk Top Charger 220/230 V AC 50 Hz 10043951
Lithium Ion Battery 10043960
EVOLUTION 5000 Truck-Mounted
Charging System 10038977
Wrist Strap 10039516
Shoulder Strap 10039515
Retractable Lanyard 10040226
Carabiner 10040005
Sun Shroud 10039603
Reflective Trim Kit 10040163
Disposable Display Covers 10038970
Non-Charging Mounting Bracket 10039602
Carrying Case 10040223
Tripod Mount 10040229
Video Out Cable SMA to BNC 10040004
Instruction Manual 10044503
Truck Mounted Charging System
Fig. 21: Location of Power Cable, Phoenix Connector and
Internal Fuse
Power Cable / Phoenix Connector
Internal Fuse
Power Cable / Phoenix Connector
Internal Fuse

Table of Contents

Other manuals for MSA EVOLUTION 5000

Related product manuals