Safety Regulations
PrimaX
6
GB
1 Safety Regulations
1.1 Correct Use
The PrimaX Gas Transmitters are fixed gas transmitters for measuring toxic or
combustible gases and for monitoring oxygen deficiency, excess or inerting. They
are suitable for outdoor and indoor applications without limitations, e.g. offshore in-
dustry, chemical and petrochemical industry, water and sewage industry. The sig-
nal of the transmitter can be used in combination with MSA control units for further
actions in safety or non safety applications, e. g. MSA SUPREMA, Gasgard XL,
9010/9020.
The two versions of the gas transmitter are delivered either in a flameproof or in a
intrinsically safe enclosure. The electrical parts and interfaces have the same basic
functionality.
It is imperative that this operating manual be read and observed when using the
product. In particular, the safety instructions, as well as the information for the use
and operation of the product, must be carefully read and observed. Furthermore,
the national regulations applicable in the user's country must be taken into account
for a safe use.
Alternative use, or use outside this specification will be considered as non-compli-
ance. This also applies especially to unauthorised alterations to the product and to
commissioning work that has not been carried out by MSA or authorised persons.
1.2 Liability Information
MSA accepts no liability in cases where the product has been used inappropriately
or not as intended. The selection and use of the product are the exclusive respon-
sibility of the individual operator.
Product liability claims, warranties also as guarantees made by MSA with respect
to the product are voided, if it is not used, serviced or maintained in accordance with
the instructions in this manual.
Danger!
This product is supporting life and health. Inappropriate use, mainte-
nance or servicing may affect the function of the device and thereby se-
riously compromise the user's life.
Before use the product operability must be verified. The product must
not be used if the function test is unsuccessful, it is damaged, a compe-
tent servicing/maintenance has not been made, genuine MSA spare
parts have not been used.
To Next Page
Loading...
Need help?
General
