3-12
MS-9638 Server Board
I/O Device Configuration
Serial Port A/B
This is used to enable or disable the onboard serial port A/B.
Base I/O Address
These items specify the base I/O addresses of the onboard serial port A/B.
Interrupt
These field allows you to select IRQ Resources for serial port A/B.
Floppy Disk Controller
Select [Enabled] if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install add-on FDC or the system
has no floppy drive, select [Disabled] in this field.
9638v3.0-3.P65 2007/5/8, 下午 01:5412
To Next Page
Loading...
