Installing VIA Chipset Drivers
5-9
Note: Install Windows
®
NT4.0 Service Pack 6 or above before installing the
VIA drivers into Windows
®
NT.
Installing VIA® Chipset Driver
1. Insert the provided CD disk into the CD-ROM drive.
2. The CD will auto-run and the setup screen will appear.
3. Click on VIA Chipset Drivers and the screen will show VIA Service
Pack 4.XX.
4. Click Next and the screen will show the VIA Service Pack 1
README dialog box.
5. Click Ye s to proceed and then select Install to enable (Ultra) DMA
for IDE Driver.
6. The Choose Destination Location dialog box appears. Click Next.
7. The Select Program Folder dialog box appears. Click Next.
8. Click on “Yes, I want to restart my computer” and then click Finish to
restart your computer and complete installation.
Installing VIA® AC97 PCI Sound Driver
1. Make sure the supplied CD disk is in the CD-ROM drive.
2. Go to My Computer and double click the CD-ROM icon. The setup
screen will appear again.
3. Click on VIA AC97 PCI Sound Drivers and the screen will show the
VIA PCI Audio Drivers setup screen.
4. The setup program will show Install or Uninstall. Select Install and
click on Next.
5. The setup program will show the following message on the screen:
Then click OK.
6. Follow the steps shown in Step 5 to finish the VIA AC97 PCI Audio
Drivers Installation.
7. A window will appear asking “Do you want to install the joystick
Please choose “Add” from the next window
and add the following device:
VIA PCI Audio Controller
VIA MIDI External Port
Driver Installation for Windows
®
NT4.0
To Next Page
Loading...
