AWARD
®
BIOS Setup
4-21
PM Control by APM
No System BIOS will ignore APM when
power managing the system.
Ye s System BIOS will wait for APM’s
prompt before it enter any PM mode
Note :Enable this for O.S. with APM like Windows
®
98, Windows
®
NT, etc.
Video Off Option
The settings are N/A, Standby, Doze, or Suspend. This option is for
choosing the setting in which the monitor will turn off.
N/A Always turn on.
Doze During Doze mode, the monitor will be turned off.
Standby During Standby mode, the monitor will be turned off.
Suspend During Suspend mode, the monitor will be turned off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video
buffer.
DPMS Initial display power management signaling.
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system
to enter the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.
To Next Page
Loading...
