Chapter 4
4-22
State After Power Failure
This option will determine how the system will power on after a
power failure.
LED In Suspend
This item determines which state the Power LED will use. The
settings are Blink, Dual color, and Single color.
Blink Power LED will blink when the system enters the
suspend mode.
Dual Color Power LED will change its color when the system
enters the suspend mode.
Single Color Power LED will always remain lit.
Wake Up Events
VGA
When Enabled, you can set the VGA to awaken the system.
VGA Off
LPT & COM I/O Access LPT/COM
HDD & FDD I/O Access ON
PCI Master OFF
PowerOn by PCI Card Enabled
Wake Up On LAN/Ring Enabled
RTC Alarm Resume Disabled
Date (of Month) 0
Resume Time (hh:mm:ss) 0:29:0
IRQs Wake Up Event ON
IRQs Activity Monitoring Press Enter
Item Help
Menu Level >
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-safe defaults F7:Optimized Defaults
To Next Page
Loading...
