Intel ICH5R Serial ATA RAID Introduction
B-13
Install Driver in Windows XP / 2000
h New Windows XP / 2000 Installation
The following details the installation of the drivers while installing Win-
dows XP / 2000.
1. Start the installation:
Boot from the CD-ROM. Press F6 when the message "Press F6 if you
need to install third party SCSI or RAID driver" appears.
2. When the Windows XP Setup window is generated, press S to specify
an Additional Device(s).
3. Insert the driver diskette Intel IAA RAID XP Driver For ICH5R
(FW82801ER) into drive A: and press <Enter>.
4. Choose Intel(R) 82801ER SATA RAID Controller from the list that
appears on Windows XP Setup screen, press the <Enter> key.
5. Press <Enter> to continue with installation or if you need to specify
any additional devices to be installed, do so at this time. Once all
devices are specified, press <Enter> to continue with installation.
6. From the Windows XP Setup screen, press the <Enter> key. Setup will
now load all device files and then continue the Windows XP
installation.
h Existing Windows XP / 2000 Driver Installation
1. Insert the MSI CD into the CD-ROM drive.
2. The CD will auto-run and the setup screen will appear.
3. Under the Driver tab, click on Intel IAA RAID Edition.
4. The drivers will be automatically installed.
h Confirming Windows XP / 2000 Driver Installation
1. From Windows XP / 2000, open the Control Panel from My Computer
followed by the System icon.
2. Choose the Hardware tab, then click the Device Manager tab.
3. Click the "+" in front of the SCSI and RAID Controllers hardware
type. The driver Intel(R) 82801ER SATA RAID Controller should
appear.
Installing Software
To Next Page
Loading...
