EasyManuals Logo

MSI 865PE/G Neo2-P MS-6728 User Manual

MSI 865PE/G Neo2-P MS-6728
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
MS-6728 ATX Mainboard
C-6
If user selects a RAID 0 array in step 2, the block size of the array can also
be selected. Use the arrow key to highlight Block Size and press <Enter>,
then select a block size from the popup menu. The block size can be 4KB to
64KB.
After array mode is selected, there are two methods to create a disk
array. One method is “Auto Setup” and the other one is “Select Disk Drives”.
Auto Setup allows BIOS to select the disk drives and create arrays automatically,
but it does not duplicate the mirroring drives even if the user selected Create
and duplicate for RAID 1. It is recommended all disk drives are new ones when
wanting to create an array. Select Disk Drives lets the user select the array
drives by their requirements. When using Select Disk Drives, the channel
column will be activated. Highlight the target drives that you want to use and
press <Enter> to select them. After all drives have been selected, press <Esc>
to go back to the creation steps menu.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSI 865PE/G Neo2-P MS-6728 and is the answer not in the manual?

MSI 865PE/G Neo2-P MS-6728 Specifications

General IconGeneral
BrandMSI
Model865PE/G Neo2-P MS-6728
CategoryMotherboard
LanguageEnglish

Related product manuals