3-17
BIOS Setup
FDC/LPT/COM Ports, Primary/Secondary Master/Slave IDE
These items specify if the BIOS will monitor the activity of the specified
hardware peripherals or components. If set to Monitor, any activity
detected on the specified hardware peripherals or components will wake
up the system or prevent the system from entering the power saving
modes. Settings: Monitor, Ignore.
Set WakeUp Events
Press <Enter> and the following sub-menu appears.
USB Device Wakeup From S3
This item allows the activity of the USB devices (keyboard and mouse) to
wake up the system from S3 sleep state. Setting: Enabled, Disabled.
Resume On PME#
This field specifies whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected. Settings: Enabled, Disabled.
Resume By RTC Alarm
This is used to enable or disable the feature of booting up the system on
a scheduled time/date from the soft off (S5) state. Settings: Enabled,
Disabled.
To Next Page
Loading...
Need help?
General
