MSI MEG X299 CREATION - Page 89

89
BIOS Setup
f Clockgen Features (optional)
Press Enter to enter the sub-menu. Sets the detailed clockgen features.
fDynamic Frequency Control [Disabled]
Enables or disables to try different CPU BCLK under CPU loading to overclock the
system. This item will be disabled when the Dynamic Frequency Search is enabled.
fDFC Baseline (MHz) [Auto]
Sets initial BCLK for dynamic overclocking if not reach the threshold. This item will
be available when the Dynamic Frequency Control is enabled
fThreshold 1~3 (A) [Auto]
Sets the CPU current as the threshold for Dynamic Frequency Control. When
CPU current reaches the value, it will run the Level 1/ 2/ 3 BCLK for dynamic
overclocking. These items will appear when the Dynamic Frequency Control is
enabled.
fLevel 1~3 BCLK (MHz) [Auto]
Sets the CPU BCLK for the threshold. These items will appear when the Dynamic
Frequency Control is enabled.
fDynamic Frequency Search [Disabled]
Enables or disables to run the optimized dynamic BCLK. This item will be disabled
when the Dynamic Frequency Control is enabled.
fDynamic Frequency Search Mode [Once]
Sets the search mode of the dynamic BCLK. This item will be available when the
Dynamic Frequency Search is enabled.
[Once] Run once in the next system boot.
[Each Power On] Run in every time when system is powered on.
fDynamic Frequency Search Step (MHz) [Auto]
Sets the increase for running the dynamic BCLK. If set to Auto, BIOS will configure
this setting automatically. This item will be available when the Dynamic Frequency
Search is enabled.
fBCLK Amplitude [Auto]
Sets the value for BCLK Amplitude for overclocking. Higher value might benefit to
get higher overclocking.
fSRC Clock Amplitude [Auto]
Sets the value for SRC clock Amplitude.
fSATA Clock Amplitude [Auto]
Sets the value for SATA clock Amplitude.
fBCLK Slew Rate [Auto]
Sets the value for BCLK Slew Rate for overclocking. The value might vary
depending on the actual overclocking scenario.
fBCLK ORT Duration [Auto]
Sets the value for BCLK ORT duration for overclocking. The value might vary
depending on the actual overclocking scenario.