Chapter 1
Hard Disk Connectors: IDE1 & ШЕ2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100
controller that provides PIO mode 0-4, Bus Master, and Ultra DMA 33/66/100
function. You can connect up to four hard disk drives, CD-ROM, 120MB
Floppy (reserved for future BIOS) and other devices. These connectors sup-
port the provided IDE hard disk cable.
ШЕ1 (Primary IDE Connector)
The first hard drive should always be connected to IDEI. IDE1 can
connect a Master and a Slave drive. You must configure second hard
drive to Slave mode by setting the jumper accordingly.
ШЕ2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
r TIP:
If you install two hard disks on cable, you must configure the
second drive to Slave mode by setting its jumper. Refer to the
hard disk documentation supplied by hard disk vendors for
jumper setting instructions.
2-14
To Next Page
Loading...
