Chapter 3
3-24
State After Power Failure
This item specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
On Reboots the computer.
Off Leaves the computer in the power off state.
Auto BIOS automatically determines the best mode.
LED In Suspend
This item configures how the system uses power LED on the case to indicate
the sleep/suspend state. Available options are:
Single The power LED turns off during the sleep/suspend mode.
Dual The power LED changes its color to indicate the sleep/
suspend state.
Wake Up Events
Press <Enter> to enter the sub-menu and the following screen appears.
USB Resume from S3, VGA, LPT & COM I/O Access, HDD & FDD I/O
Access, PCI Master, PowerOn by PCI Card, Wake Up On LAN/Ring,
IRQs Wake Up Event
These fields specify whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected.
Note: To use the function of “Wake Up On LAN/Ring” , you need to
install a modem/LAN card supporting power on function.
RTC Alarm Resume
The field is used to enable or disable the feature of booting up the system
Wake Up Events
USB Resume from S3 Disabled
VGA OFF
LPT & COM I/O Access LPT/COM
HDD & FDD I/O Access ON
PCI Master OFF
PowerOn by PCI Card Disabled
Wake Up On LAN/Ring Disabled
RTC Alarm Resume Disabled
Date (of Month) 0
Resume Time (hh:mm:ss) 0 0 0
IRQs Wake Up Event ON
IRQs Activity Monitoring Press Enter
Item Help
Menu Level 88
x
8
x
To Next Page
Loading...
