3-18
MS7036 M-ATX Mainboard
SuperIO Device
Press <Enter> and the following sub-menu appears:
POWER ON Function
This controls how the PS/2 mouse or keyboard can power on the system.
Settings: [Password], [Hot KEY], [Mouse Left], [Mouse Left], [Mouse Right],
[any KEY], [BUTTON ONLY], [Keyboard 98].
KB Power ON Password
If POWER ON Function is set to Password, then you can set a password in the
field for the PS/2 keyboard to power on the system.
Hot Key Power ON
If POWER ON Function is set to [Hot KEY], you can assign a hot key combi-
nation in the field for the PS/2 keyboard to power on the system. Settings: [Ctrl-
F1] through [Ctrl-F12].
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select [Disabled] in this field. Setting options: [Enabled], [Disabled].
Onboard Serial Port 1/Serial Port 2
This item specifies the base I/O port address and IRQ for the onboard Serial Port
1 (LPT1B)/Serial Port 2 (JCOM1). Selecting [Auto] allows BIOS to automatically
determine the correct base I/O port address. Setting options: [Disabled], [3F8/
IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3], [Auto].
UART Mode Select
This setting allows you to specify the operation mode for serial port 2. Setting
options: IrDA, ASKIR, Normal.
NormalRS-232C Serial Port
IrDA IrDA-compliant Serial Infrared Port
ASKIR Amplitude Shift Keyed Infrared Port
To Next Page
Loading...
