3-7
BIOS Setup
LBA/Large Mode
This item allows you to enable or disable the LBA (Logical Block Address,
the logical block size in hard disk) mode. Setting options: [Auto], [Disabled].
DMA Mode
This item allows you to enable or disable the DMA (Direct Memory Access)
mode. Setting options: [Auto], [SWDMA0], [SWDMA1], [SWDMA2],
[MWDMA0], [MWDMA1], [MWDMA2], [UDMA0], [UDMA1], [UDMA2],
[UDMA3], [UDMA4], [UDMA5].
Hard Disk S.M.A.R.T.
This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis &
Reporting Technology) capability for the hard disks. S.M.A.R.T is a utility
that monitors your disk status to predict hard disk failure. This gives you an
opportunity to move data from a hard disk that is going to fail to a safe place
before the hard disk becomes offline. Settings: [Auto], [Enabled], [Disabled].
Floppy Drive A
This item allows you to set the type of the floppy drives installed. Available
options: [Disabled], [360 KB, 5
1/4
], [1.2 MB, 5
1/4
], [720 KB, 3
1/2
], [1.44 MB, 3
1/2
],
[2.88MB, 3
1/2
].
Halt On
The setting determines whether the system will stop if an error is detected at
boot. Available options are:
[No Errors] The system doesn’t stop for any detected error.
[All, But Keyboard] The system doesn’t stop for a keyboard error.
System Information
Press <Enter> to for the sub-menu of each item:
Total System Memory/BIOS Version/CPU/CPU ID/uCode ID/CPU Fre-
quency
This item shows the memory status and BIOS version of your system and
the CPU information (read only).
To Next Page
Loading...
Need help?
General
