3-13
BIOS Setup
AGP Aperture Size
This setting controls just how much system RAM can be allocated to AGP
for video purposes. The aperture is a portion of the PCI memory address
range dedicated to graphics memory address space. Host cycles that hit
the aperture range are forwarded to the AGP without any translation.
Setting options: [32M], [64M], [128M], [256M], [512M] and [1G].
AGP 3.0 Mode
The item sets an appropriate mode for the installed AGP 3.0 card. Setting
options: [8x], [4x].
AGP Driving Control
This field is used to adjust the AGP driving force. Selecting [Manual] allows
you to select an AGP driving force in AGP Driving Value. It is strongly
suggested to select [Auto] to avoid causing any system error. Setting
options: [Manual], [Auto].
AGP Driving Value
This item specifies an AGP driving force.
AGP Fast Write
The item enables or disables the AGP Fast Write feature. The Fast Write
technology allows CPU to write directly into the graphics controller without
passing anything through system memory and improves 8x speed
accordingly. Select [Enabled] only when your AGP card supports the feature.
Options: [Disabled], [Enabled].
AGP 3.0 Calibration cycle
This setting disables/enables the AGP auto calibration. Setting options:
[Disabled], [Enabled].
VGA Share Memory Size
The system shares memory to the onboard VGA card. This setting controls
the exact memory size shared to the VGA card. Setting options: [Disabled],
[16M], [32M], [64M].
To Next Page
Loading...
Need help?
General
