B-7
ATI SATA RAID Setup Guide
1. Select “Resolve Conflicts”
2. Select the “Invalid RAID drive” entry in the Logical Drive Status window and
press Enter.
3. Follow the prompts to resolve the conflict.
Note that some conflict resolutions may result in the drive letter assignment changing;
for example the RAID set may have been drive D: but after the conflict resolution, it
may become drive E:. To maintain the same drive lettering, you may need to swap the
SATA cable connected to the drive, or in the case of a SATA-based removable drive
unit, you may need to change the order of the drives within the chassis.
u Low Level Formatting
The Low Level Format item selection allows you to completely erase the data on a
hard drive. However this is a very drastic process and not typically needed. Format-
ting the drive under Windows is usually sufficient to delete the data.
To Next Page
Loading...
Need help?
General
