MSI X58 Pro-E seres - Fan Power Connectors; Front Panel Connectors

Hardware Setup ▍
MS-7522
2-15
Hardware Setup ▍
MS-7522
Important
Please do not fold the Seral ATA cable nto 90-degree angle. Otherwse, data loss
may occur durng transmsson.
Please always use the Intel default SATA connectors (SATA1~6) 󰘰rst.
Front Panel Connector: JFP1, JFP2
Ths connector s for electrcal connecton to the front panel swtches and LEDs. The
JFP1 s complant wth Intel
®
Front Panel I/O Connectvty Desgn Gude.
1.+
3.
-
10.No
Pi
n
5.
-
Reset
S
witch
HDD
LE
D
P
ower
S
witch
P
ower
LE
D
7.
+
9.Reserve
d
8.
-
6.
+
4.
-
2.
+
JFP1
1
.Ground
3.Suspend
LE
D
5.Power
LE
D
7.No
Pi
n
8.
+
6.
-
4.
+
2.
-
Buzzer
S
peaker
JFP2
Fan Power Connectors: CPUFAN1, SYSFAN1~3
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con
-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
1
.
G
r
o
u
n
d
2
.
+
1
2
V
3
.
S
e
n
s
o
r
4
.
C
o
n
t
r
o
l
1
.
G
r
o
u
n
d
2
.
+
1
2
V
3
.
S
e
n
s
o
r
1
.
G
r
o
u
n
d
2
.
+
1
2
V
3
.
N
o
U
s
e
CPUFAN1 SYSFAN1/2 SYSFAN3
Important
Please refer to the recommended CPU fans at processor’s o󰘲cal webste or consult
the vendors for proper CPU coolng fan.
CPUFAN1 supports fan control. You can nstall
Overclockng Center utlty that wll
automatcally control the CPU fan speed accordng to the actual CPU temperature.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN1.
SYSFAN1 and SYSFAN2 support fan control, too. You may select how percentage of
speed for the SYSFAN1/2 n BIOS.
•
•
•
•
•
•