To Next PageTo Next PageHow to fix dirty water in MSpa Hot Tub?
If the water in your MSpa Hot Tub isn't clean, it could be due to several factors. If the water has been used for a long time, change it. If the filtering time is insufficient, extend it. Also, if the filter cartridge is dirty, clean or replace it promptly. Finally, ensure proper water maintenance by referring to the chemical manufacturer’s instructions.
What to do if my mspa Bergen C-BE062 Hot Tub loses air?
If your MSpa Hot Tub is losing air, it could be due to a loose air valve or a hole/split in the spa tub. Inflate the spa until the yellow section of the manometer is pushed out, and ensure the valve is screwed tightly, replacing it if necessary. For holes or splits, apply soapy water to the seams to locate the leak, then clean and dry the area before applying the repair patch supplied with your spa. Check the repair section on P14.
What to do if there is no display on the control panel of my MSpa Hot Tub?
If there is no display on the control panel of your MSpa Hot Tub, first check the power socket. Change to a working socket or repair the existing one if it's faulty. Also, check if the PRCD is off; if so, reset it by following the PRCD Testing section.
How to fix an MSpa Hot Tub that loses air?
If your MSpa Hot Tub is losing air, first check if the air valve is loose. Inflate the spa until the yellow section of the manometer is pushed out, and ensure the valve is screwed tightly. If necessary, replace the valve. Also, inspect the spa tub for any holes or splits. If you find a leak, clean and dry the area, then use the repair patch supplied with your spa.
Why does the filter pump not work in my mspa Bergen C-BE062?
If the filter pump in your MSpa Hot Tub isn't working, it could be because the filter cartridge is clogged by dirt or other objects. Try cleaning or replacing the filter cartridge.
What to do if my MSpa Hot Tub is leaking?
If your MSpa Hot Tub is leaking, first check if the spa in&outlet connection is securely tightened. If not, tighten the connection. Also, ensure the drainage valve is completely closed. If water leaks from the spa pool body, repair the leaking hole/split with the repair kit material.
What to do if my mspa Hot Tub is not heating properly?
If your MSpa Hot Tub is not heating properly, there are several potential causes. * The temperature might be set too low, so try setting a higher temperature. * A dirty filter cartridge can also cause heating issues; clean or replace it. * Ensure the water level is at least at the minimum water line; if not, add more water. * If the heater has failed or the filter pump isn't working, contact your local MSpa Service Center.
Guidelines for choosing and preparing a suitable installation site for the spa.
Step-by-step instructions for testing the Ground Fault Circuit Interrupter (GFCI) plug.
Instructions for checking and maintaining correct air pressure using the manometer.
How to use and activate the UVC sanitizing system for water purification.
Instructions for operating the heating system and adjusting water temperature.
How to operate the filtration system and the filter cartridge cleaning reminder.
Instructions for using the bubble massage function and important safety notes.
How to set and cancel the timer for the heating system activation.
Steps for inspecting and cleaning the filter cartridge regularly.
Table listing error codes, their causes, and suggested solutions.
Common problems, their causes, and recommended solutions for spa operation.
General
