www.mtpinc.com 17
TIME (Clock) Setting
1. While Clock is blinking, press MODE/ SET key to access the Clock Setting Interface.
The Hour value will start flashing.
2. Press the ▲ or ▼ key to increase or decrease value.
3. Press the MODE/ SET key to confirm these digits and move on to minute value.
4. Repeat the same steps you have done for Hour value. After the last digit has been
validated, the general setting mode screen will show up.
NOTE : If you need to go back to Clock setting, use ▲ or ▼ key to select the Clock
Symbol again.
DATE Setting
1. While 01/01/2011 is blinking, press MODE/ SET key to enter into Date Setting
Interface. The Year value will start flashing.
2. Press the ▲ or ▼ key to increase or decrease value to set the Year.
3. Press the MODE/SET key to confirm this digit and move on to the next digit. After
Year value has been set, the Month value will start to flash.
4. Press the ▲ or ▼ key to increase or decrease value to set the Month. Press
MODE/SET key to confirm. After the Month value has been set, the Day value will
start to flash.
5. Press the ▲ or ▼ key to increase or decrease value to set the Day. Press
MODE/SET key to confirm. After the last digit has been confirmed, the general setting
mode screen will show up.
NOTE : If you need to go back to Date setting, use ▲ or ▼ key to reselect Date value.
TEMPERATURE UNITS
1. While Temp is blinking, press MODE/ SET key to enter into Temp. Unit Setting
Interface. The Celsius (°C) symbol will flash.
2. Press ▲ or ▼ key to choose between °C and °F units, then press MODE/ SET key
to confirm. The general setting mode screen will show up.
BUZZER ON/OFF
1. While bOFF is blinking, press MODE/ SET key to access the Buzzer Setting
Interface.
2. Press ▲ or ▼ key to choose between ON and OFF status, then press MODE/ SET
key to confirm. The general setting mode screen will show up.
Note : When the buzzer is set to ON, the bell icon will appear on the top right corner
of the display screen.
To Next Page
Loading...