Table of Contents
Section Page
1. Introduction 1
2. General Software Information 2
3. Model Number Information 7
4. Level Plus Tank Monitor Specification 8
5. Monitor Installation and Electrical Terminations 9
6. The Control Panel 16
7. Keypad Control Functions 18
8. Error Message Descriptions 22
9. Pre Start Up Check List 28
10. Start Up 29
11. Programming the Level Plus 30
12. System Parameters 34
13. Gauge and Tank Parameters 43
14. Side Tank Indicator Parameters 51
15. Analog Parameters 52
16. Volumetric Parameters 54
17. System Test Functions 67
18. Ending the Programming Sessions 75
19. Level Plus Host Communication Protocol 76
20. DDA Level Plus Monitor Modbus Implementation 87
Appendices Page
A. Procedure for Calculating Volume Correction Factors (VCF) 89
B. Typical RS232 Printer Connections 90
C. Scan Rate Calculation Procedure 91
D. EPROM Replacement Procedure 95
E. Connecting Level Plus DDA monitor to MTSLPS80 Software System 100
F. Level Plus Monitor Modbus Register Maps 101
NOTICE TO USER:
See section 9 of this manual for important information
about the installation, setup, and use of this product.
To Next Page
Loading...
Need help?
General