Relay Polarity
The relay output polarity can be software programmed for normally open (NO) or nor-
mally closed (NC) operation. The relay contacts are internally wired as normally open
when the relay coils are de-energized, allowing the user to program the system for “fail-
safe” relay control. (i.e. relay outputs are open when alarms are active).
Press the MODE key to change the relay polarity or press the ENTER key to continue.
Audible Beeper Control
The audible sonalert beeper can be enabled to signal keypad key depressions (audible
feedback) and/or system alarms. Press the MODE key to enable or disable the keypad
audible beep. The new beep control selection will not take effect until program mode is
exited.
The system alarm audible beep can be disabled, enabled for all alarms or enabled for
alarms assigned to relay #0 only. Press the MODE key to select the desired alarm audible
beep mode.
If the alarm audible beep is enabled, the alarm audible beep rate can be set for FAST,
MEDIUM or SLOW beep rates. Press the MODE key to select the desired beep rate.
This completes the SYSTEM parameter programming section. Press ENTER to return to
the SELECT EDIT FUNCTION menu.
ALARM AUDIBLE BEEP
RATE = FAST
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
ALARM AUDIBLE BEEP
DISABLED (OFF)
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
KEYPAD AUDIBLE BEEP
ENABLED (ON)
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
RELAY OUTPUTS OPEN
WHEN ALARM IS ACTIVE
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
42
To Next Page
Loading...
Need help?
General