18
Start-Up
Once normal wiring is verified, power can be applied to the amplifier.
Assure the input settings are what are required. Jumper default settings are for 6-pole motors.
The ENABLE Input will disable the drive if it is not connected.
The CUR and RESP adjustments are turned down (CCW). CUR is 50% and RESP is
minimal.
It is recommended that CUR be turned to its full CCW position. Once power is applied, CUR
can be slowly increased in a CW direction to achieve shaft torque. Crispness can be
increased by a CW adjustment of RESP.
To Next Page
Loading...
