Warnings (CPAP)
accessory Directions for Use, all precautionary information, and
oxygen-enriched environments, or nitrous oxide.
Electrical shock hazard. An operator may only perform maintenance
required, contact your MTTS representative to repair this equipment.
Do not modify this equipment without authorization of the manufacturer.
performance.
Do not operate the device if any of the components appear to be damaged or
broken. Damaged or broken components should be discarded and replaced.
Do not position the device in a location that reduces its ventilation.
Do not block any of the air vents on the sides or bottom of the device.
The presence of electro-surgical devices, shortwave or microwave equipment
near this device could lead to electrical interference that would negatively
affect the function of the device.
the
Reprocessing (CPAP)
section. The device must be cleaned and disinfected
according to this section before each use with a new patient.
components without cleaning or disinfection between patients can result in
infections.
Warnings (CPAP)
operator or damage to the device.
Adding heat to the patient circuit above ambient temperature levels could
result in higher condensation in the inspiratory tube. This includes heat add-
ed through incubators, overhead warmers or blankets covering some part of
the heated patient circuit.
To Next Page
Loading...