Setup (CPAP)
Attach the metal plug by sliding it on to
chamber and twisting to engage the
locking mechanism.
Attach the screw cap by twisting it onto
the threads until a tight seal is formed.
Setup (CPAP)
if water is leaking from either the metal
plug or the screw cap.
If no leaks are observed, carefully carry
the heater plate.
If leaking occurs, check that the parts are correctly assembled and not
damaged. Discard and replace any damaged parts.
1. Assemble and ll the humidier.
Ensure the metal plug o-ring and the screw cap o-ring are both present.
To Next Page
Loading...