Abbrevia-
tion
Meaning Explanation
IIG Initial Injector Equalization Entering of injector code with DiaSys in engine gover-
nor
IMO International Maritime Organization
ISO International Organization for Stand-
ardization
International umbrella organization for all national
standardization institutes
KGS Kraftgegenseite Engine free end in accordance with DIN ISO 1204
KS Kraftseite Engine driving end in accordance with DIN ISO 1204
LCD Liquid Crystal Display, Liquid Crystal
Device
LCU Local Control Unit LOP subassembly
LED Light Emitting Diode
LMU Local Monitoring Unit LOP subassembly
LO Low Range violation alarm (1st lower limit value)
LOLO Low Low Range violation alarm (2nd lower limit value)
LOP Local Operating Panel Control console, control panel
LOS Local Operating Station
MCS Monitoring and Control System
MG Message
MPU Microprocessor Unit, Microprocessing
Unit
OT Oberer Totpunkt Top Dead Center
P-xyz Pressure-xyz Pressure measuring point xyz
PAN Panel Control panel
PCU Propeller Control Unit Propeller controller
PIM Peripheral Interface Module
RCS Remote Control System
RL Redundancy Lost Alarm: Redundant CAN bus failure
SAE Society of Automotive Engineers U.S. standardization organization
SAT Sea Acceptance Test
SD Sensor Defect Alarm: Sensor failure
SDAF Shut Down Air Flap(s) Emergency air-shutoff flap(s)
SILA Fuse lamp on EIM
SOLAS International Convention for the Safety
of Life at Sea
SS Safety System Safety system alarm
SSK Schnellschlussklappe(n) Emergency air-shutoff flap(s)
T-xyz Temperature-xyz Temperature measuring point xyz
TD Transmitter Deviation Alarm: Deviation in transmitter values
UT Unterer Totpunkt Bottom Dead Center
VS Voith Schneider Voith-Schneider drive
WJ Water jet Water jet drive
WZK Werkzeugkatalog Tool catalog
ZKP Zugehörigkeit-Kategorie-Parameter Assignment category parameter; number scheme for
signals from the ADEC engine governor
174 | Appendix A | M015650/06E 2018-05
TIM-ID: 0000002050 - 007
To Next Page
Loading...
