B-16 701333-004
Programming Notes
Setting the Escape Character
To set the escape character:
1. Press the Stop key, if the printer is ready.
2. Enter Menu mode.
3. Select Option 503.
4. Press the Left Arrow or Right Arrow key until the number of the escape character
you want is displayed. Refer to Figure B-2.
5. Press the Save key to activate this escape character, and press Stop to quit.
To display the number of the escape character, follow Steps 1 through 3.
Final Step
Finally, use Configuration Option 804, APA Print Direction, in Chapter 4 for better bar
code registration.
1. Press the Stop key.
2. Enter Options mode.
3. Select Option 804.
4. Press the Left Arrow or Right Arrow key until 1 is displayed.
5. Press the Save key to store this choice. The printer will now print unidirectionally.
To Next Page
Loading...