MTX 1330-X02 - Character Set Selection Commands; Language Set Selection Commands

701333-004 B-35
Programming Notes
Character Set Selection Commands
Character set selection commands are listed below.
noitcnuF edoC lamiceD xeH
1teSretcarahCCPtceleS7CSE557273B1
2teSretcarahCCPtceleS6CSE457263B1
teSretcarahCllAmorfsuounitnoCtnirP2n1n\CSE2n1n29722n1nC5B1
teSretcarahCllAmorfretcarahCenOtnirP^CSE4972E5B1
Character Set Selection Commands
Note: (n1) and (n2) specify the number (n) of characters to be printed from the all
character set, where n = 256n2 + n1.
Language Set Selection Commands
A language set selection command is listed below.
noitcnuF edoC lamiceD xeH
egaugnaLrotarepOtceleS1mL2n1n>LEB<[CSE701972
1m672n1n
70B5B1
1mC42n1n
Language Set Selection Commands
Note: n1 and n2 specify the number (n) of parameters that follow, where n = 256n2 +
n1. For most language selections n1 = 02 and n2 is always 00.
L specifies the use of the operator panel language selection, which is based on
Configuration Option 201 (Chapter 5 of this manual).
m1 specifies the language option to be used (Configuration Option 201). For
example, m1 = 02 selects the PC Multilingual Character Set.