MTX 1330-X02 - Page 8

701333-004 ix
Page
List of Illustrations
Figure 2-1. Unpacking the 1330 .................................................................2-2
Figure 2-2. Foam Shipping Tube ................................................................2-3
Figure 2-3. Shifting Ribbon Cartridge........................................................2-5
Figure 2-4. Platen Gap Lever......................................................................2-5
Figure 2-5. Disengaging the Ribbon Shifter Guide ....................................2-6
Figure 2-6. Nonshifting Ribbon Cartridge..................................................2-7
Figure 2-7. Installing the AC Power Cord ..................................................2-9
Figure 2-8. Connecting the Coax Cable .....................................................2-9
Figure 2-9. Connecting a Parallel or Serial Cable ....................................2-10
Figure 2-10. Forms Specifications - Physical Requirements ......................2-12
Figure 2-11. Forms Specifications - Print Positioning................................2-13
Figure 2-12. Print Positioning - Continuous Forms....................................2-14
Figure 2-13. Print Positioning - Single Part Forms.....................................2-15
Figure 2-14. Paper Feed Slots.....................................................................2-17
Figure 2-15. Open Tractor Door .................................................................2-18
Figure 2-16. Flipping the Tractor Lever .....................................................2-18
Figure 2-17. Inserting Paper - Continuous Forms Module .........................2-19
Figure 2-18. Platen Gap Lever....................................................................2-20
Figure 2-19. Forms Handler Module (DOD Option) ..................................2-21
Figure 2-20. DOD Option with Roller Drive..............................................2-23
Figure 2-21. Forms Handler Module (DID Option) ...................................2-23
Figure 2-22. Inserting Paper - Forms Handler Module...............................2-24
Figure 2-23. DID Option with Roller Drive ...............................................2-25
Figure 3-1. 1330 Operator Control Panel ...................................................3-1
Figure 3-2. Status Display ..........................................................................3-1
Figure 4-1. Aligned and Unaligned Dots in Characters............................4-19
Figure 5-1. Aligned and Unaligned Dots in Characters............................5-16
Figure 7-1. Replacing the Print Head .........................................................7-3
Figure 7-2. Carriage Restraining Hook ......................................................7-3
Figure 7-3. Mounting Screws .....................................................................7-4
Figure 7-4. Carriage - Side View ................................................................7-5
Figure 7-5. Proper Print Registration..........................................................7-5
Figure 7-6. Increase Print Registration Value .............................................7-7
Figure 7-7. Decrease Print Registration Value............................................7-8
Figure B-1. Escape Sequence Structure ................................................... B-13
Figure B-2. Table for Selecting Escape Character ................................... B-15
Figure B-3. Escape Codes ........................................................................B-18
Figure B-4. Bar Code Types .....................................................................B-20
Figure B-5. Calculating New Line Characters ......................................... B-23
Figure B-6. OCR-A Character Set ........................................................... B-25
Figure B-7. OCR-B Character Set ........................................................... B-26